How to tear down a Blaster motor and rebuild with modded parts

[callmej75]

I may do that at a later date...when more funds are available. Right now i wanna focus on at least getting to ride it before i turn 40...although more power is always enticing to the male species

[ROCKSTAR]

Originally Posted by ZillaFreak

if you are looking for a pipe, talk to a pipe builder like shearer, i am sure he would build you one.

probably be a bit cheaper to go with somebody besides shearer. not to mentiona a hand coned pipe will run probably starting around 600 bucks

and a yz250 engine in a blaster would probably be a f-ing rattle can. most times, dirt bike engines in quad vibrate like a bitch because they dont run a counterbalaner.

[callmej75]

Yeh i saw vids of the vibrations from the yz250 in a blaster...bad vibrations. Eh it was a thought...but its passed. The vibrations would screw up my back even more since my hands already go numb while sitting still at my desk. I haven't saw too many other swaps that fit as well as that tho...

[245stroker]

If your looking for a custom cone pipe you should look into a dyno port, I had them build one for my blasty.

[drifz1]

how much do all the parts cost for a bottom end ?